Skip to content

For manufacturers

Connect equipment duty to the system it serves.

MEPFlow helps HVAC and hydronic manufacturers, suppliers and application teams review project loads, airflow, water flow and connected layouts before equipment-selection discussions.

A useful equipment discussion starts with the building and the system around it. Bring room demand, design temperatures and distribution routes into the same project so your application team can work through the conditions behind a request. MEPFlow provides the design calculations and layout context; use your product data and selection tools to match the equipment to that duty.

Start with the project duty

Review heating and cooling loads by room or zone, together with the design assumptions behind them. A change to the envelope, occupancy or room conditions can change the duty being discussed. Use a shared set of project inputs to explain the requirement to the designer, contractor and equipment supplier.

Explore Heating & Cooling Loads

Put airflow in its system context

Use the ductwork layout to review terminal airflow, connected branches, duct sizes and the critical-path pressure calculation. Discuss how a revised route or airflow affects the fan duty, then check the proposed equipment against its published performance at the intended operating point.

Explore HVAC Ductwork

Review water-side operating conditions

Relate heating or cooling duty to the design temperature difference and required water flow. Inspect connected pipe routes, sizes and circuit pressure loss to prepare application discussions for coils, heat sources, chillers and pumps. Keep the selected product's pressure drop and operating limits alongside the system calculation.

Explore Hydronics

Discuss radiant floor applications

Review heated areas, floor assumptions, loop layouts and manifold locations in the project. Compare room demand with the calculated floor contribution, circuit flow and loop head. Use those results with the proposed floor system's product data to discuss output, routing and any additional heat needed.

Explore Underfloor Heating

Turn a project change into a clearer equipment discussion.

Design changeWhat to revisitUseful MEPFlow workflow
A room's cooling duty increasesCooling load, airflow and the coil's design conditionsHeating & Cooling Loads with HVAC Ductwork
A coil is moved farther from the plantWater flow, pipe route and circuit pressure lossHydronics layout and sizing
The heated floor area becomes smallerFloor contribution, circuit layout and remaining room demandUnderfloor Heating room and loop review

Keep the project assumptions and revision visible when sharing results. Use the outputs available in each module to support the application discussion, then complete equipment selection against the manufacturer's performance data.

Practical questions before you start

Who is this workflow for?

Manufacturer application engineers, technical sales teams and suppliers working with designers or contractors on HVAC, hydronic and radiant floor systems. Start with a representative project and use the modules relevant to the equipment you support.

Does MEPFlow automatically select products from our catalog?

Equipment selection stays in your manufacturer tools and product data. MEPFlow supplies the project loads, flows and layout context for that selection; it does not currently connect to a manufacturer product catalog.

Can we review a project over its floor plan?

Yes. Use a PDF drawing, assign the relevant page to a floor and establish its scale. Lay out the supported system and review the sizing results in that project context.

Can we see the workflow before starting a trial?

Yes. The public demos show the supported design modules, and the free calculators can be used without an account. Contact us with the equipment type and application you want to discuss.

How does the free trial work?

Create an account, verify your email and activate the trial through Stripe checkout. A card is required: US$0 today, then US$49/month after 7 days unless canceled. Cancel anytime through Billing & subscription in your app account menu.

Try it on a design you can check.

Start with a small project, confirm the inputs and calculation basis, and review how the layout and results fit your process.

7 days free. Then $49 USD/month. Card required. Cancel anytime.